ДЭУ-1300

The main design feature of the drill is reinforced reduction gearbox that increases the torque of the drill significantly . Compared with the usual single body housing (drill body and gearbox are integrated) the aluminum cast gearbox improves the heat transfer from the instrument and has a higher durability.

Very powerful 1300W drill engine combined with high torque allows to use the specialized tooling, such as hollow cutter head (80 mm), pen-type and spiral drill of large diameter.  Drill is equipped with chuck with capacity up to 16mm for this purpose.

Switch with electronic adjustable speed. Speed ​​control depends on pressure used on a button. Infinitely variable speed control allows you to make drilling accurate and precise from the very beginning.

Speed adjustment wheel on the trigger allows you to set the rotation speed before start. Preset is very important for drilling holes in the low-melting materials such as plexiglass. Also it also makes sense to use the speed preset while using a drill as a screwdriver because the screws are very hard to screw at 3000 rmp.

The weight and dimensions of the machine are much bigger than the screwdriver but in case of an emergency its possible to use the same way. Reverse function and electronic speed adjustment allows you to use a drill as a screwdriver.

Thanks to the speed adjustment and reverse function (standard wheel on the trigger switch) you can use a drill ДЭУ-950 for threading. You just need to set up appropriate accessories.

Special multi-layer heat-resistant lacquer coating protects the motor windings from short circuit when overheated.